2 Piece Seat Installation


Our 2 pce toilet seats (both resin and wooden) have adjustable hinges, which allow the seat to move approx 2-5cm, up-down and across to fit the fixing holes on your bowl.
Contents:
-
2 x plastic washers
-
2 x rubber washers
-
2 x small plastic washers
-
2 x metal nuts
-
2 x threaded rods
-
1 x nut tool
Please complete the following before placing on your toilet bowl.
-
Screw the Threaded Rod into Position B to start.
-
Loosen screw A slightly and lay the toilet seat onto the toilet pan.
-
Turn the round base plates equally on both sides into the approximate position so threaded rods will pass through the toilet pan holes.
-
If you are happy with the fit, remove the seat and tighten screw A.
-
Proceed with step 4. If awider adjustment is required, screw metal rod into position C and start again.
-
Place the two large plastic washers over the threaded rods, and place the seat onto the toilet pan, passing the threaded rods through the pan holes.
-
Check that the seat is aligned and slide the two black rubber washers, the 2 smallplastic washers and the metal nuts onto the threaded rods from underneath, tighten with the nut tool. Place the nut tool in a safe place for future use.